Residential Meter Install

SaskEnergy Network Members and licensed Heating Contractors can book work orders for the installation of a new residential meter or on properties where gas service has been inactive for over one year. A residential meter is considered anything under 300,000 BTUs. 

Contractors are not required to be on site during the meter install, however the air test verification must be completed prior to booking. 

How to Book a Work Order

Complete the form below. You will receive an email within 24 hours including the date the meter will be installed. 

Before you Begin

To complete this work order request, you will need to:

  • Read and understand the site readiness requirements
  • Read and understand the installation standards section 6.22 CSA B149.1
  • Read and abide by SaskEnergy's Terms & Conditions of Service Schedule - Appendix G
Residential Meter Install Request Form
Gas Contractor Information
To be used for text or call ahead notification.
Site Representative Information
That will be onsite completing the work.
Will Technical Safety Authority of Saskatchewan be on site?
Meter Information
Is this a temporary or permanent permit number?
Meter 2
Is this a temporary or permanent permit number?
Meter 3
Is this a temporary or permanent permit number?
Meter 4
Is this a temporary or permanent permit number?
Meter 5
Is this a temporary or a permanent permit number?
Meter 6
Is this a temporary or a permanent permit number?
Meter 7
Is this a temporary or permanent permit number?
Meter 8
Is this a temporary or permanent permit number?
Meter 9
Is this a temporary or permanent permit number?
Meter 10
Is this a temporary or permanent permit number?
Meter 11
Is this a temporary or permanent permit number?
Meter 12
Is this a temporary or permanent permit number?
Installation Requirements
The meter(s) listed above are in a location accessible and free from hazards for a SaskEnergy Technician to complete the meter install.
Conditions

Note that meter(s) will not be installed if any of the following occur:

  • a dial test performed by SaskEnergy fails;
  • you cannot confirm the required pressure test(s) or that the piping is free of deficiencies or defects;
  • you cannot confirm the above referenced site readiness requirements, or SaskEnergy determines the site not to be ready in its sole discretion.
Acknowledgement
By clicking “I agree”, you:
  • acknowledge and agree the information provided is accurate and complete;
  • acknowledge that you are a licensed gas contractor in Saskatchewan;
  • acknowledge and agree to abide by SaskEnergy's Terms and Conditions of Service Schedule - Appendix G.